I quite often directed attention in shops on unusual big pictures from skin. It wanted to me to test the forces and most to create something similar. Rather it even was principle business, than mere curiosity. I am the painter and when I see something fascinating, me hunting to make even more beautiful and best of all. As though someone threw down to me a challenge. There is a spirit of rivalry. As it appears, it not and is difficult. Wish, and you I will teach. A picture of the skin remains under force to make though to what needlewoman.
I bring to your attention a master class on manufacturing of a big picture from skin.
1. So, we will begin. Direct attention to this picture. It is a pattern. With its help cut out two malekhanky petals, two average and three huge. big pictures from skin
2. From below make cuts on the designated lines.
3. Further we need to process over open fire fire lateral faces and the highest part of a petal. It is necessary for this purpose that they were curved and became big.
4. Bottom edge of a malekhanky petal miss the mark with glue, then аккуратненько curtail and strongly clamp.
5. All following petals need to be distributed moderately round the first: paste from above one small, then two average and three huge. Each new petal paste approximately in the middle of the previous. It will give naturalnesses to a flower.
6. When the rose will absolutely dry, its lower part cut off a writing knife or a cutting torch. So it will be easier to strengthen it on base of a picture.
7. From green skin cut out three details simulating чашелистики. Here pattern.
8. A bud of a rose create from 2-3 stuck together boundaries itself petals. From above paste чашелистики. Try to distribute them around approximately how it is shown in drawing.
Quantity of petals of roses and their size regulate. The various number of the pasted petals will allow to receive a rose of the huge and malekhanky sizes.
I produce leaves from thick skin. On the discretion you can use some flowers in a picture. In this work the blue palette prevails.
9. Cut out leaves on this pattern.
Make in the center their cuts – leaf pro-veins.
10. Further them it is necessary to burn, but there is one cunning. It is better to do it on a frying pan. It will give them more equal and convex surface. Under the influence of heat of a pro-vein will reveal.
11. For branches and stalks cut out from skin of a strip of different width so that one end of a strip was thinner than another.
12. For stalks cut out strips more extensively, than for branches.
13. Cut out from skin small triangles. They will serve us as thorns.
14. Burn over a candle flame all prepared details a little.
Well here, all elements are ready, there came the most fascinating moment – picture assembly.
15. The prepared base fix in a frame.
16. Distribute branches, trunks, leaves, florets, чашелистики, and buds on base as is shown in drawing.
17. Later alternately paste all details. Yes, and one more small cunning. When awake to paste leaves, put glue only on a leaf contour. The convex surface should be not pasted. It will be only this way possible to keep the volume acquired by means of roasting.
After the picture will absolutely dry, can hang up it on a wall. Beauty well and only. It will decorate with herself though what interior.
Also do not fear to dream, the sketch can be made though what. At me the whole collection of these delightful pictures already gathered.