For furnish of walls and a ceiling as decorative materials only the equal surface will serve. On walls with shortcomings and roughnesses it is not represented probable to paste wall-paper or other products. Here for this purpose also it is necessary to plaster a surface. It is necessary to dissolve a dry mix, and for laborious mixing of solution it is necessary to use a low-resourceful drill with a nozzle "mixer". It is necessary to do preparation of a plaster consistence by only malekhanky portions to avoid hardening that will result in unfitness in work. After drying it is necessary by all means погрунтовать already plastered surface.
That it was more clear, the above-stated procedure is similar both for walls, and for a ceiling. It is possible to consider as the subsequent step a surface shpatlyovka. It is the special structure applied to high-quality furnish. Its practical application is meaningful after rough alignment of plaster of roughnesses. Shpatlyovka do not put on a surface with a thick layer to avoid integrity violation. For convenience of introduction the shpatel whom for avoiding of sticking of a consistence it is necessary to moisten with water is used. After the shpatlyovka will harden, its surface is required to be finished to ideality by means of a grinding skin. On degree of readiness is: dry shpatlyovka, also shpatlyovka ready to application which are on sale in tubes, in banks or buckets. Shpatlyovk needs to choose according to the basis on which it is put about what with pleasure advisers in a system shops will tell.
Before rough plaster processing of a surface and after a final shpatlyovka it is necessary in a neotklonimy order of a wall and a ceiling to process strengthening first coats. It is required to put a first coat moderately on all surface with the roller, and in inaccessible places – a brush. Very absorbing bases become covered few times therefore as after priming the expense of the following materials will essentially be reduced in few times. The first coat that is important, works and as an antiseptic.
After all walls and a ceiling will thoroughly dry up, it is possible to start furnish. So, at all so long ago in the Russian market appeared it is comparable a new construction material – glass-fiber wall-paper which in the West are successfully used more than fifty years. Стеклообои are issued the standard sizes in rolls on 25 and 50 meters at length at width in 1 meter. It should be noted that they are convenient, are recoloured in colors – economically, and in additives and it is harmless. Стеклообои create from mineral and ecologically spotless materials: quartz sand, soda, lime, dolomite. They do not cause an allergy, have the highest pozharobezopasnost, watertightness.
For a sticker стеклообоев it is better to use special glue therefore as glue holds heavy wall-paper thanks to the overestimated gluing possibility and quick drying. Glue can be as in dry in a look which it is necessary to dissolve in water, and in already prepared, watery look. By means of the roller it is necessary to put glue on a surface equal on width of one strip of a roll. The sketch of wall-paper remembers the fabric interlacings, sliding light reveals structure of wall-paper which are painted later. It is necessary to mean that the last coloring smoothes a drawing relief, but to paint wall-paper it is possible only after their complete drying. It is most ideal to use special, water dispersive paint on latex base. Normal 0 false false false RU X-NONE X-NONE MicrosoftInternetExplorer4